Graco InvisiPac 24R136 30 Gallon Vibrating Hopper Kit

Graco InvisiPac 24R136 30 Gallon Vibrating Hopper Kit Overview

The Graco InvisiPac 24R136 30 gallon vibrating hopper allows for even dispensing of hot melt into your InvisiPac system. The hopper includes a shaker to make sure the hot melt pellets remain level at all times. This system stops hot melt in the container from clumping which can prevent even suction from the vacuum system.

Installation Instructions for the InvisiPac 24R136

1. Turn main power switch OFF.
2. With the steel shaker rod fully assembled and the 3/8 in. OD air line connected to the shaker head, cut the 3/8 in. OD air line where the 1.3 in. clear vacuum transfer hose connects to the steel shaker rod.
3. Use the splitter fitting (917) to reconnect the 3/8 in. OD air line that was just cut.
4. Install the 48 in. section of 3/8 in. OD hose supplied with the kit into the remaining connection on the splitter fitting (917).
5. Connect the other end of the 48 in. section of 3/8 in. OD air line to elbow fitting (916) on the piloted air valve.
6. Connect shop air to elbow fitting (914) on the piloted air valve. Shop air must be capable of 100 psi (0.7 MPa, 7 bar). NOTE: The piloted air valve must use shop air. Adding a tee at the system inlet to run the hopper shaker may impact pump and vacuum transfer performance.
7. Place steel shaker rod assembly into hopper (901) with steel rod resting in the hopper groove in the rim of the hopper.
8. Place lid (902) on hopper (901). NOTE: The hopper shaker will be active while the vacuum transfer system is transferring pellets. ___‰äó_

* Input Air Pressure Requirement: 100 psi (7 bar, 0.7 MPa) Air Consumption: 17.1 scfm (29.1 cubic meters per hour)