TEC 6300 Hot Melt Gun Review
The TEC 6300 Pneumatic Hot Melt Gun is truly impressive. This heavy duty hot melt gun is ideal for heat sensitive materials. The TEC 6300 lays down an adjustable spray pattern of hot melt allowing users to cover a wide surface area. Use different spray nozzles to even further fine tune the amount of adhesive and pattern being delivered.
Power Adhesive TEC 6300 Specs:
- Sprayable Hot Melt Gun
- Temperature
- 500 Watt Heater
- 9.2 lbs. of Hot Melt per Hour
- Finger Trigger
- Spray Air Regulator
- Air Compressor Required
- Warranty 12 Months
TEC 6300 Setup:
The TEC 6300 a pneumatic spray hot melt gun is easy to get ready to go. You do need to have an air compressor to use this gun, which is a slight bummer but we think it's worth it. Plug the TEC 6300 into the compressor and then plug it into the wall. The gun takes about 10 minutes to warm up and then you are good to go.
The TEC 6300 In Action:
The TEC 6300 is a beast, no joke that's what we are going to start calling it. This pneumatic spray hot melt gun weighs 3.1 lbs which is not too bad for what this heavy duty gun can do. Turning out about 9.2 pounds per hour the TEC 6300 is ideal for demanding applications.
Conclusion:
The TEC 6300 looks a bit overwhelming at first, but to our shock it was actually quite easy to use. We loved the using this spray gun. It made it so easy to cover a large area in no time. Since this extraordinary hot melt gun covers materials so quickly and evenly there is less hot melt wasted. The TEC 6300 is perfect for using on heat sensitive materials like foam and fabric.
Recommended for:
- Heat Sensitive Materials
- Product Assembly
- Packaging
Recommended Adhesives
- TEC 420 - Medium open time
- TEC 425 - Long open time
- TEC 430 - Very long open time
- CastTEC 42 - Precast Concrete
Purchase:
Any questions on our review? Feel free to use our contact form or give us a call 1-877-933-3343.